KTEB Teterboro Airport Full

Teterboro Airport (IATA: TEB, ICAO: KTEB, FAA LID: TEB) is a general aviation relief airport situated in the boroughs of Teterboro, Moonachie, and Hasbrouck Heights in Bergen County, New Jersey. It is owned and managed by the Port Authority of New York and New Jersey, and operated by AFCO AvPORTS Management. The airport is in the New Jersey Meadowlands, 12 miles (19 km) north-northwest of Midtown Manhattan, making it popular for private and corporate aircraft. The airport has a weight limit of 100,000 pounds (45,000 kg) on aircraft, making it nonviable for any commercial service.

The airport takes up almost all of Teterboro and consists of 827 acres (3.35 km2): 90 acres (0.36 km2) for aircraft hangar and offices, 408 acres (1.65 km2) for aeronautical use and runways, and 329 acres (1.33 km2) undeveloped. The airport has more than 1,137 employees, of whom more than 90% work full-time.

In April 2009, the Federal Aviation Administration (FAA) reported that the airport had the third-highest rate of wildlife strikes of any airport in the United States, based on takeoffs and landings (43 per 100,000).

Teterboro is home to many private aviation charter companies flying both nationally and globally.

KTEB was promised quite a while back and I finally took the time to complete the full airport. All models are handcrafted including the new ATC tower. There are 8 open hangars with animated doors that are open from 6am to midnight. The doors can be open/closed by hiding/unhiding the flight yoke during hours that they are closed.

This area was a little laggy using developers mode, even before I started adding models. I decided to make the scenery as modular as possible to assist you with removing some items if you have problems running it on your system.

Things to try if the scenery is laggy

Reduce the amount of ground aircraft and vehicles. I had issues with the amount of parked aircraft, but I reduced the amount which helped.

Removing some items from the scenery. Browse to jd-airport-kteb-teterboro and you can remove the CGL directory. If that don't help, browse to jd-airport-kteb-teterboro\Scenery\airport-kteb-teterboro, and you can remove some or all of the fences directories. The scenery will work just fine without these items.

Known Issues

Default KTEB ATC sometimes broadcast messages for Caldwell ground on 121.900, with routes to runways 22 and 28 via taxiways N and E.

This information is from KCDW, Essex County airport, Caldwell NJ. You can use 120.675, which is listed as ramp control on the airport diagram.

To install

Extract the archive and copy jd-airport-kteb-teterboro to your community folder