A SPAD.neXt profile for the A2A Piper Comanche PA24-250 using the Honeycomb Alpha yoke and Bravo throttle quadrant.
This profile uses LVARs which must be installed in SPAD.neXt under Settings > Config Wizard > "Install SPAD.neXt LVAR Bridge (MSFS)".
You will need to map the Alpha pitch/roll axis either in a MSFS controller profile, or customise this SPAD.neXt profile to add it. The pitch and roll axis, elevator and rudder trim switches, and hat switch of the Alpha yoke are not mapped in this SPAD.neXt profile, as I prefer to have those setup within my default MSFS control profile.
I use a blank MSFS control profile with the Bravo throttle quadrant, so all the axis for that are included in this SPAD.neXt profile.
Current control setups are:
Honeycomb Alpha Controls:
- ALT Switch - Headphons on/off
- BAT Switch - Master battery on/off
- BUS1 Switch - Avionics master on/off
- BUS2 Switch - Radios on/off (COM/NAV/ADF)
- BCN Switch - Beacon light on/off
- LAND Switch - Left landing light on/off
- TAXI Switch - Right landing light on/off
- NAV Switch - Nav & Instrument lights switch on/off
- STROBE Switch - Strobe lights on/off
- MAG OFF Switch - Magnetos off
- MAG R Switch - Right Magnetos
- MAG L Switch - Left Magnetos
- MAG BOTH Switch - Both Magnetos
- MAG START Switch - Starter engage (releases when switch is released)
- Left white thumb button - ALT ENG/DISENG button
- Right red thumb button - AP DISC button
- Right white thumb button - Toggle tablet
Honeycomb Bravo Controls:
- Axis 1 - Throttle
- Axis 1 Button - Primer (unlocks, pumps once, then locks)
- Axis 1 Detent - Chocks, tie downs, pitot cover on
- Axis 3 - Prop
- Axis 5 - Mixture
- Axis 5 Detent - Chocks, tie downs, pitot cover off
- Axis 6 - Carb heat
- Gear lever - Gear up/down (gear switch goes to neutral after landing gear confirm up and locked)
- Flaps - Flaps
- Rocker switch 1 - Fuel pump on/off
- Rocker switch 2 - Autopilot master switch on/off
- Rocker switch 3 - Pitot heat switch on/off
- Rocker switch 4 - Transponder ALT/SBY
- Rocker switch 5 - Left fuel tank selector main/off
- Rocker switch 6 - Right fuel tank selector main/off
- Rocker switch 7 - Parking brake on/off (brakes must be held to set)
- HDG AP Button - Long press to cage/uncage gyro (light will flash)
- NAV AP Button - Cycle through turn coordinator AP push modes (light will turn on)
- ALT AP Button - Engage/disengage altitude hold (light will turn on)
- AUTO PILOT Button - Cycle through turn coordinator AP push modes (light will turn on)
- Rotary knobs
- HDG mapped to heading bug
- CRS mapped to CDI needle
- ALT mapped to altimeter setting (inHg/hPa setting in Kollsman window)
- Right rotary knob will control gyro drift card if gyro is uncaged (long press HDG AP button)
- All relevant lights on Bravo annunciator panel are setup
9 months ago
tackleberry
10 months ago
Yelmanor
10 months ago
amadi7